Vaping Guides


Benefits of priming your coil
You are going to want to know how to prime your atomiser coil as by priming your atomiser coil correctly, you will eliminate burn hits, heighten the flavour intensity and add longevity to your coil. When an atomizer coil is unused, the wicking material is completely dry. Since it is making contact with the coil, once heated the cotton will burn resulting in an unpleasant charred taste.
By pre-saturating the coil, you will prevent this from happening since the liquid will be vaporized rather than the cotton being burned. In addition, you will experience full flavour from the first use.

Step one: Attach the new atomiser Coil
Once the old coil has been disposed of, screw on the new one in its place. This will give you something larger to hold onto while you’re adding e-juice to the coil. It also helps prevent e-liquid from getting on your fingers, as screwing it on after the wick has been saturated could cause it to get on your fingers as well.

Step two: Saturate the wicking Material
The next step in priming your clearomizer coil is to locate the juice holes on the body of the atomizer head, where the wick makes contact with the e-liquid. Some coils are designed with the cotton sticking out of the holes, while others have the wick behind them. In either case, the wicking material will be exposed and easily visible. Add one single drop of e-juice in each of the holes in order to uniformly saturate the wick.
Next, saturate the cotton with e-juice. Depending on the specific atomizer coil you are using, the amount of e-juice necessary to adequately saturate the wicks will vary. Smaller atomizer coils, will require a drop or two of e-liquid, whereas the substantially larger heads that operate with the tanks, will require much more to accomplish this. You will know when you have added enough e-juice when the cotton stops immediately absorbing it. However, make sure not to over-saturate, as this may cause flooding and allow for liquid to get into your mouth. Remember, your goal isn’t to drench the coil, it is solely to saturate the cotton.

Step 3: Take some Dry Hits
Once you have filled and reassembled the tank, attach it to your battery. The next step in priming your coil is to take 4 – 5 dry hits. A dry hit simply means to take a drag without activating the fire button of your battery. Simply tighten the airflow valve (if your tank has one), cover the air intake holes with your hand, and take four or five normal drags. By doing this, you will syphon e-juice from the tank and into the cotton. However, be sure not to take too deep or strong of hits, nor take more than five of them, as it could cause the coil to flood.

Step 4: Break in the Coil
Although the most important factor in priming coil is to saturate the wicking material, it is also significant to properly break-in the new wire. Since the wire expands when heated and contracts when it cools, it is good practice to gradually break the wire in as well. To do so, start using the new coil at a lower wattage than you normally do. After a few hits, you can gradually increase the wattage until you reach your normal power setting. It also helps if you take shorter hits for the first 10 drags, so that the wire is not excessively heated at first. This steady increase in wattage and puff duration will ensure that the coil is properly primed along with the cotton.

Now you know how to prime your atomiser coil.

To shop our full range of vape kit atomiser coils please CLICK HERE.

Share this post

Leave your thought here

Your email address will not be published.